Configure UAPP Domain Email Filters
Apply ordered domain-wide email rules before mailbox and Sieve rules, with owned-domain selection and restrictions on folder actions.
Open Hosting → Email → Domain Filters.
Domain rules run before mailbox filters and Roundcube Sieve rules. The target must be an owned primary, addon or alias domain; this view does not offer wildcard names or arbitrary subdomains as domain-filter targets.
Fields and actions
Use the same rule name, enabled state, all/any match, message-field comparisons, ordered actions and ruleset controls described in Email Filters. The target is a domain rather than one mailbox.
Domain filters cannot move or copy messages into mailbox folders. Use a mailbox filter for those actions. Domain rules can redirect, discard or stop processing. Terminal actions prevent downstream mailbox/Sieve processing for affected messages.
Limits remain 100 rules per filter, 20 conditions and 10 actions per rule, with no more than one terminal action and that action last. Addresses, values, patterns and action order must pass validation.
Review and verify
- Confirm the domain and intended breadth of the match.
- Configure and order the rules.
- Review terminal actions, then save.
- Test matching and nonmatching mail for multiple affected recipients.
Enable, disable, delete and supported legacy-conversion actions operate on the selected domain ruleset. Demo mode blocks mutations. Review converted rules and preserve any needed legacy backup before deleting a filter.
One domain rule can affect many mailboxes
Avoid broad discard or redirect rules without a recovery plan. A later mailbox rule cannot undo an earlier terminal domain action.