Add IPv4 Address
Register a single IPv4 address or an inclusive range in Eenos, with required gateway, subnet mask and interface settings.
Open Network & DNS → IP Addresses → Add IPv4. Choose the single-address form or the range form.
Requirements
Use addresses allocated to this server by your provider. Confirm the correct interface, dotted subnet mask and gateway before submitting. The interface selector lists detected interfaces except loopback. Demo sessions cannot submit changes.
Single IPv4 Address
| Field | Required value |
|---|---|
| IPv4 address | One valid IPv4 address, without a CIDR suffix. |
| Subnet mask | A dotted IPv4 mask such as 255.255.255.0, using the provider's actual setting. |
| Gateway | A valid IPv4 gateway supplied by your provider. |
| Network interface | The interface on which the address belongs. |
- Complete all four fields.
- Click Add IPv4 Address.
- Read the result and check List IPv4 Addresses.
- Verify the address on the interface and test connectivity before assigning it to an account.
The form rejects an exact duplicate already recorded on the selected interface. It does not establish that the address is unallocated elsewhere.
IPv4 Address Range
| Field | Required value |
|---|---|
| Starting address | The first IPv4 address to add. |
| Ending address | The last IPv4 address to add, greater than the starting address. |
| Subnet mask | Dotted mask applied to every address in this submission. |
| Gateway | IPv4 gateway applied to every address. |
| Network interface | Interface used for the entire range. |
Click Add IPv4 Range after reviewing every address. Both endpoints are included. Starting and ending addresses must share their first three octets, even if the supplied subnet mask describes a larger network. Equal endpoints are rejected; use the single-address form for one address.
For illustration, 192.0.2.10 through 192.0.2.12 adds three addresses. These documentation addresses must be replaced with your real allocation.
Review existing entries before a range import
The range path merges entries into the selected interface inventory and can overwrite existing address settings. It does not perform the single-address duplicate check for every entry. Exclude addresses already configured, reserved addresses and addresses outside your provider allocation.
Result and troubleshooting
Eenos saves the address, subnet and gateway in inventory, then calls the IPv4 activation helper. A successful submission reports IP address added successfully. or IP address range added successfully. The activation result is not reliably reflected in that message; independently verify connectivity.
An invalid range order or different first three octets produces a validation error. For a duplicate, inspect the existing entry rather than submitting it again. If saving fails or a range is only partly applied, review the inventory and actual interface state before retrying. The form validates IPv4 syntax but does not prove that the mask, gateway and provider topology are compatible.