Skip to Content
Browse documentation

Configure Service Monitoring

Set Eenos automatic monitoring, check interval and recovery attempts, and enable or disable individual or selected services with confirmation.

Open System → Service Monitor → Monitor Settings.

Global policy fields

FieldBehavior
Monitor servicesGlobal on/off switch for automatic monitoring and recovery. The changed switch takes effect after saving.
Check IntervalInteger seconds between monitoring cycles; minimum 30.
Recovery AttemptsInteger attempts to recover an inactive service; minimum 1.

Review the displayed values rather than assuming a server's policy. Choose Save Settings, review Save Monitoring Settings and confirm to apply, or cancel. The form validates the interval and attempt count before submission.

A successful settings write requests a restart of the monitoring daemon so it can load the policy. The save result reports configuration persistence; verify the monitor and later behavior before assuming automatic recovery is functioning. Monitoring cycles include work time and are not an exact service-recovery deadline.

Per-service monitoring

The table shows a selection checkbox, service name and unit, description, Monitoring Status, and the enable/disable action. Search and sort to locate the intended service; the default page size is 25.

Use a row's Enable monitoring or Disable monitoring action, inspect the selected service in the confirmation and confirm. Enabled means that service participates when global monitoring is also on. It does not mean the service itself is active.

Bulk actions

Select service rows and choose Enable Selected or Disable Selected. The header checkbox applies to rows matching the current table search across table pages. Selections persist while paging or changing the search, so review the selected set before confirming.

The confirmation identifies the number of selected services. No selection produces a prompt to select services. Rows already in the requested monitoring state are excluded before submission; if all selected rows already match, the page reports that no applicable services remain.

Global settings, single-service actions and bulk actions are separate submissions. Save edited global policy explicitly rather than expecting a row action to save it.

Requirements and verification

Demo sessions cannot save monitoring changes. Validation or write failures are reported on the page; successful and failed settings operations are recorded as service activity events. After saving, recheck the displayed policy and per-service state and inspect Service Status.

Enable recovery deliberately

Enabling monitoring can cause automatic restart of inactive services. Disabling it removes that recovery behavior without stopping the service. Coordinate maintenance and investigate repeated failures before increasing recovery attempts.

Read the monitoring behavior and failure-suppression rules before relying on recovery. For an intentional manual service operation, use Service Restart.