Setup Hostname DNS
Install, rebuild or remove the local DNS zone for the Eenos server hostname using its shared addresses.
Open Network & DNS → DNS → Setup Hostname DNS.
What the page shows
The page displays the current server hostname, primary shared IPv4/IPv6, local zone installation status and, when found, the zone file path. The hostname and addresses are informational here; they are not editable inputs.
To change these settings, use Change Hostname or Basic Setup.
Requirements
Configure a valid server hostname, at least one server nameserver and at least one valid shared IPv4 or IPv6 address. The local DNS tools and backend must be usable. The submitted hostname must match the actual server hostname.
Install or rebuild
- Review the hostname and shared addresses.
- Click Install Zone when absent, or Rebuild Zone when installed.
- Review the confirmation and click Continue.
- Read the result and verify authoritative answers.
The builder generates SOA, NS, address records for the configured shared addresses and an SPF TXT record. It validates the generated zone, installs it, registers it with the DNS backend and requests a reload. An existing zone receives an updated SOA serial.
Rebuilding replaces generated zone content
This is a generated infrastructure zone. Preserve any manual additions before rebuilding; rebuilding writes the generated content again. A failure late in installation can leave changed files, so inspect the resulting state before retrying.
Delete the local zone
When installed, Delete Zone opens a confirmation. Check the hostname and click Continue only after confirming that local authoritative service is no longer required.
Deletion removes the local DNS zone through the backend. It does not change the machine hostname, parent-zone records, registrar settings, reverse DNS or certificates.
Installation status reflects local zone-file presence, not an end-to-end public resolution check. If the page reports an I/O or build failure, review DNS logs and the shared-address/nameserver settings.